KORG microKORG 1.0.1

microKORG Synthesizer / Vocoder Since its release in 2002, the microKORG has been loved by more musicians around the world than any other hardware synth in music history. Following the first generation microKORG, a number of variations were introduced, including the microKORG XL released in 2009 and the microKORG S with 2+1 speakers, as well as many color variations.

The microKORG was born out of a desire to bring the appeal and fun of synthesizers to beginner and professional musicians, track makers, and creators everywhere. Korg easily achieved this goal,creating a wildly successful synthesizer that was not only compact andeasy to use but sounded amazing.
Oscillator section with a variety of waveforms.
In the oscillator section, which is the basis of tone, two oscillators can be used per voice. Oscillator 1 has 8 built-in waveforms, including sawtooth wave, square wave, and audio input, and you can also select the DWGS waveform, which has 64 built-in waveforms. Each waveform can be processed with the two[CONTROL 1/2] knobs (DWGS is waveform selection only) for even more versatile sound creation. Oscillator 1 also has an oscilloscope that displays waveform changes in real time. Oscillator 2 contains only the basic waveforms of sawtooth, square, and triangle waves, and can also perform oscillator-to-oscillator modulation such as ring modulation, cross modulation, and hard sync.
Filter section for processing sounds, Amp section that controls the volume.
The sound from the oscillator goes through the mixer and then into the filter section. The filter section incorporates four types of filters, allowing the sound from the oscillator to be processed as desired. The low-pass filter also has a sharp 24dB mode.
- After passing through the filter, the sound enters the amplifier section. Here you can adjust the overall...

Read more

Continue reading...